5

I am using I2C to communicate between a collection of ATtiny85s that are acting as controllers for various parts of a system and the "Main Brain" -- a RaspberryPi. Most of the ATtiny85s only have a couple of free pins left (usually Pins 1 and 2 -- the reset and the pin that can't be used for PWM) so I can't use something like a DIP switch to directly set device IDs. I'd rather not hardcode the device IDs when I push code to the tinys but I can't think of a good, simple, and reliable way to do it otherwise. Anyone here have a suggestion?

ThatAintWorking
  • 240
  • 2
  • 9

2 Answers2

6

Put the address in EEPROM. It's still "on the chip" but it can be programmed independent of the flash, and can be changed on the fly if deemed appropriate.

Ignacio Vazquez-Abrams
  • 17,723
  • 1
  • 28
  • 32
1

You could use the analog input on pin 1.

Have a table in your code to map voltage thresholds to I2C IDs.

Then build a voltage divider circuit as input that you can adjust with switches or by installing different resistors.

Craig
  • 2,120
  • 10
  • 11