Most Popular

1500 questions
7
votes
2 answers

Using Arduino for simultaneous lighting effects

I am building a computer for my son (me). I'm trying to spark his interest in computer technology, so my idea is to drive multiple case lighting effects with a microprocessor or controller. I went with the arduino over the pi because of simplicity…
7
votes
1 answer

ESP8266 & websockets

At the moment, I'm using various operating systems and devices like the Raspberry pi to control lights and other stuff over websockets. I use websockets since they added the support on Chrome. I write a lot of Javascript stuff for fun. Websockets…
cocco
  • 451
  • 5
  • 7
  • 16
7
votes
1 answer

Why does increasing resistance make a capacitive sensor more sensitive?

From the Capacitive Sensor Page on the Arduino website, it states the following: The capacitiveSensor method toggles a microcontroller send pin to a new state and then waits for the receive pin to change to the same state as the send pin. A…
Kenneth .J
  • 393
  • 1
  • 5
  • 11
7
votes
3 answers

Sending and receiving different types of data via I2C in Arduino

I have found a few good tutorials on how to send and receive data via I2C in connected arduinos. My limitation is now how to transmit different types of data like for instance, long, float, etc. Right now the communication via I2C using the wire…
Camilo
  • 359
  • 2
  • 5
  • 12
7
votes
2 answers

arduino creates strange files in SD card

I'm new to Arduino and electronics. I want to make a project including SD data-logger, but I had a problem. I would appreciate if someone show me where I made a mistake. Firstly, circuit was set up as in picture: I am using 8 Gb micro SDHC card…
dursung
  • 71
  • 1
  • 1
  • 2
7
votes
5 answers

Programming arduino via bluetooth module issue

I followed a tutorial on how to setup arduino and bluetooth so it can be programmed without usb cables. I didn't use capacitors or resistors asthere doesn't seem to be a need for them. I have the serial output appearing on arduino serial console via…
DominicM
  • 597
  • 3
  • 7
  • 13
7
votes
1 answer

Arduino sizeof Servo array objects is.. wrong?

After searching for a quite long while over the internet, I have no choice but to try asking someone if they can explain me this apparently strange situation. I'm doing some tests using some servo motors, trying to move them almost together using…
briosheje
  • 173
  • 2
  • 6
7
votes
1 answer

Playing audio files with sine wave from arduino

So, when searching for a way to play audio files through the Arduino, I came across this site: How to play WAV audio files with Arduino Uno and MicroSD card This seems like a really good library (although I haven't had the time to really play around…
jaredad7
  • 173
  • 7
7
votes
1 answer

Communication with two XBee's and Arduinos over serial

I have two XBee's connected to two Arduino Uno boards (one for each XBee). I connected each XBee to the X-CTU software, and have set the following: XBee 1 Pan ID = 4270 DL = 10 MY = 20 XBee 2 Pan ID = 4270 DL = 20 MY = 10 Both DD = 10000 IC =…
nathpilland
7
votes
4 answers

Adjust time calculation after Timer0 frequency change

I have an Arduino Nano with an 328P and need all 6 PWM pins. Thus, I had to adjust the prescaler and WGM Mode of Timer0. It is now in phase correct PWM mode with a prescaler of 1. TCCR0A = _BV(COM0A1) | _BV(COM0B1) | _BV(WGM00); TCCR0B =…
Splitframe
  • 173
  • 5
7
votes
2 answers

Level detection of 3.3V from 5V arduino

A quick question about microcontroller digital level on I/O pins. I have a photo interrupter which is powered at 3.3V which is interfaced to Arduino UNO running at 5V. For microcontroller to detect high or low level is determined by signal higher…
David Norman
  • 173
  • 1
  • 6
7
votes
2 answers

Control/count rotations of a DC motor

Using an Arduino and an L293D IC, can I control the number of rotations a DC motor makes? Or can I only control the direction and speed of the motor? I purchased a two-wheeled robot platform to learn Arduino programming and electronics. The platform…
Michael Cornn
  • 173
  • 1
  • 1
  • 4
7
votes
5 answers

CO2 sensor for arduino

I want to add CO2 measuring feature to my room weather station. Can someone please recommend a CO2 sensor easy to integrate with Arduino?
A B
  • 187
  • 1
  • 3
7
votes
1 answer

How shiftOut function works internally? (explanation on source code)

I were examining shiftOut() function code in wiring_shift.c and I didn't quite understand what is going in digitalWrite function. I see !!(val & (1 << i)) is taking the bit value from val but how exactly it works? The whole function is below. void…
wizofwor
  • 298
  • 2
  • 5
  • 13
7
votes
1 answer

strange behaviour of dtostrf()

I'm trying to program a little bit in Arduino, but I'm stuck with probably something trivial. This is what I have: char ang[3], lat[9]; dtostrf(GPS.angle, 3, 0, ang); dtostrf(GPS.latitude, 9,5, lat); Serial.println(lat); …
stUrb
  • 351
  • 2
  • 5
  • 10